From single and double DishDrawer units to the tall-tub built-in series, we diagnose and repair Fisher & Paykel dishwashers across Littleton and SW Denver. Same-day diagnostics whenever the schedule allows, honest pricing, no guesswork.
Fisher & Paykel took a different engineering path than most brands, so the repairs look different too.
The signature DishDrawer design, found on the DD24 single and double-drawer models and the newer DD60 series, replaces the traditional tub with a self-contained drawer that has its own motor, pump, and wash system. That drawer-based architecture is compact and quiet, but it means each drawer can fail independently, and the moving seal around the drawer sees far more wear than a fixed door gasket ever would.
On the tall-tub built-in dishwashers (the DW60 series), the failure modes shift toward the Smart Drive brushless motor, the flow-through water heater, and the electronic control board. Because Fisher & Paykel uses its own direct-drive motor rather than a conventional belt or shaded-pole pump, an accurate repair depends on knowing exactly which generation of Smart Drive control you are working with.
In Littleton's dry, mile-high climate, the flexible drawer seals and inlet gaskets dry out and crack faster than they would at sea level. That is one of the most common reasons a two- or three-year-old DishDrawer suddenly starts leaking, and it is a repair we see constantly.
If your DishDrawer or built-in is doing any of these, it is worth a call:
Every visit starts with a flat $89 diagnostic service call, credited toward the repair if you approve it.
We pull the stored fault codes from the Smart Drive or DishDrawer control and confirm whether the issue is the motor, the water valve, the lid/seal system, or the board itself before touching a single part.
On DishDrawer models we check the drawer motor, lid actuator, and the perimeter seal under pressure, since a slow leak here is the usual cause of the flood-protection lockout.
We inspect the inlet valve, flow-through heater, drain pump, and filters, and confirm the unit fills and empties to spec so a fresh part is not masking a second fault.
You get a firm price and a clear explanation. No repair happens until you say yes.
Fisher & Paykel parts are brand-specific, and a generic substitute rarely fits the DishDrawer geometry or the Smart Drive control. We fit OEM-quality, factory-specified components: drawer seals, lid actuators, wash and drain motors, inlet valves, and control boards matched to your exact model and serial.
For leaking drawers we replace the full seal kit rather than patching one edge, because in Littleton's dry air a partially perished seal will fail again within a season. Getting the right part the first time is what keeps these repairs lasting.
Serving Littleton, Ken-Caryl, Columbine, Chatfield, Roxborough Park, and SW Denver.
Service visits run daily from 8:00 AM to 6:00 PM, and the phone is answered around the clock. Call (720) 903-2603 or book through our online scheduling page and tell us your model number so we arrive with the right DishDrawer parts on the van.
Quick Answers
Littleton Appliance Repair is an independent service company that has repaired Fisher & Paykel dishwashers, including single and double DishDrawer models and the tall-tub built-in series, since 2014. We cover Littleton and the SW Denver metro within about 25 miles. Call (720) 903-2603 to book; the phone is answered 24/7.
We charge a flat $89 diagnostic service-call fee, which is credited toward the repair once you approve it. The final price depends on the on-site diagnosis, such as a drawer seal kit, lid actuator, or Smart Drive control board. You always get a firm quote before any work begins.
On DishDrawer models a leak usually comes from a perished perimeter drawer seal, and the water reaching the base trips the flood-protection sensor and locks the drawer. Littleton's dry, high-altitude air dries these seals out faster than at sea level. Replacing the full seal kit clears the fault; a partial patch tends to fail again within a season.
FAQ
Anything else — call any hour, a real person answers.
We work on the DishDrawer single (DD24S) and double (DD24D) drawers, the newer DD60 series, and the DW60 tall-tub built-in dishwashers. If you have the model and serial number handy when you call, we can bring the matching parts.
Yes. Because each drawer has its own motor, pump, and control, one drawer can fail while the other keeps running. We diagnose and repair the affected drawer without disturbing the working one.
No. We are an independent repair company, not authorized or certified by Fisher & Paykel or any manufacturer. We use OEM-quality, factory-specified parts and have been repairing these units since 2014.
Service visits run daily from 8:00 AM to 6:00 PM, and we offer same-day diagnostics whenever the schedule allows. Call (720) 903-2603 or use our online scheduling page to grab the next available slot.
Answered 24/7 · $89 diagnostic credited to the repair
Book OnlineReviews
Our built-in Sub-Zero was keeping the freezer fine but the upper fridge zone was sitting around 55. Turned out to be the dual-evaporator setup, exactly what the tech guessed on the phone. Brian had the sealed system diagnosed the first visit, ordered the part, and had us back to normal within the week. He didn't try to sell us a new unit like the last place did.
One of the dual-stack burners on our Wolf range would click and click but never light. He mentioned it's common up here because the burners need to be calibrated for the altitude, which no one had ever told us. Relit perfectly after and he adjusted the others while he was at it.
Fixed our Sub-Zero the same week we called. Fair price, no upsell.
Our dual-zone wine cabinet had drifted so the bottom zone wouldn't hold temp and there was condensation collecting on the glass. They diagnosed it quickly but the part had to come from the manufacturer and took about four days, so we were without it for most of a week. Once it arrived the fix was solid and both zones are holding right where they should. Worth the wait, just be ready for the parts delay on these.
Miele dishwasher wouldn't drain, standing water in the bottom every cycle. Bad drain pump. In and out in about an hour and he cleaned out the filter housing that was part of the problem too.
The door gasket on our 15-year-old Sub-Zero had gotten brittle and it was sweating around the seal. New OEM gasket and it seals like new again. Appreciated that they used the factory part instead of some universal thing.
Thermador wall oven quit heating right before we were hosting. Called in the morning and they got someone out that same afternoon. Bad igniter. He had the part on the truck and we still made our dinner.
Ice maker in our Sub-Zero was making cloudy hollow cubes and barely any of them. He flushed the system, replaced a valve, and now it actually keeps up when we have people over. Nice guy, wore booties in the house without being asked.
Solid work on our Bosch dishwasher, the drain pump had failed. The only thing is the $89 service call fee felt a little steep before I knew they credit it toward the repair. Once I proceeded it came off the bill, so no real complaint, just wish I'd understood that up front.
Our Viking freezer was building up a wall of frost and not defrosting on its own. Turned out to be the defrost heater. Fixed it and explained what was going on so I understood why it happened.
Two burners on our Wolf cooktop wouldn't spark. Tech recalibrated them for the elevation and swapped the igniters. Works better than it has in years honestly.
Warm upper zone on our Sub-Zero, classic apparently. They knew exactly what it was, ordered the evaporator part, and came back to install it a couple days later. Honest and easy to deal with the whole way through.
Not many people around here will even touch a Gaggenau. These guys did, got the control board sorted, and were straight with me about the cost of the part on a unit this expensive.
Miele steam oven throwing an error and shutting off mid-cook. The tech was great and clearly knew the unit, but he ran about 40 minutes behind the window they gave me and I had to shuffle some things around. Fixed it in one visit though and it's been perfect since, so I'd still call them again.
Had them out for our built-in outdoor grill that wasn't lighting evenly. Didn't expect them to do outdoor units but they did and dialed it in for the altitude. Grilling season saved.
Quick, clean, and they answered when I called at 9pm the night before. Dishwasher's draining again.
This was a big one, the sealed system on our Sub-Zero failed and that's a job a lot of shops won't take on. They did it right, used factory-spec parts, and stood behind the work. Given it's a $12k built-in I'm glad I found someone who actually knew these inside and out instead of just replacing the whole fridge.
Wine fridge kept fogging up on the door and the temp was bouncing around. Fixed same visit and no more condensation.