Induction not heating, a gas burner that won't light at altitude, or an electric element stuck on high? Our independent technicians diagnose and repair Fisher & Paykel cooktops across Littleton, with $89 credited toward the fix.
Fisher & Paykel builds several distinct cooktop platforms, and each fails in its own way. Knowing the series tells us where to look before we ever pull the glass.
We repair Fisher & Paykel induction cooktops in the CI-series (models like CI604, CI905 and the wider CI1266 five- and six-zone flush-mount units), which rely on individual induction coils and a shared power board. We also service the CG-series gas cooktops (CG604, CG905, CG122 and the LPG/natural-gas variants) with their sealed brass burners and electronic re-ignition, plus CE-series radiant electric ceramic tops and the drop-in modular sections older kitchens still run.
Because Littleton sits near 5,350 feet, gas models get extra attention. Fisher & Paykel ships many CG cooktops with an altitude-appropriate injector set, but units relocated from sea level, or converted between natural gas and LPG, often run rich, yellow-tip, or fail to hold flame after ignition. We verify the correct orifice and regulator setup for our elevation as part of the diagnosis.
These are the failures we see most often on Fisher & Paykel units in the SW Denver metro:
Every visit follows the same disciplined process so you know exactly what you're paying for.
We identify your exact Fisher & Paykel series and read any error codes off the control panel, then reproduce the fault so we're fixing the real problem, not a guess.
We test coils, power and UI boards, spark electrodes, gas pressure, and switches with meters and known-good procedures. The $89 diagnostic fee is credited toward the repair if you proceed.
You get the specific part, the labor, and a firm price before we touch anything. Quotes are honest starting estimates confirmed after diagnosis.
We install factory-specified or OEM-quality coils, boards, electrodes, injectors, and switches, then re-test the cooktop and, on gas models, recheck flame quality for altitude.
Fisher & Paykel induction cooktops are quiet and precise, but the electronics run hot behind the glass. When a single CI-series zone dies while the others work, it's usually a specific coil or its driver, not the whole board — replacing only the failed component keeps your repair affordable.
We check the cooling fan, thermistors, and mains filter board too, because an intermittent zone or repeated shutdown is often a heat or supply issue rather than a dead coil. Getting that diagnosis right the first time is the difference between one visit and three.
We cover Littleton and the surrounding communities within about 25 miles.
Our technicians work throughout Littleton, Ken-Caryl, Columbine, Chatfield, Roxborough Park, and SW Denver. We're an independent repair company — not affiliated with or authorized by Fisher & Paykel — which means straight answers and no upselling toward a full replacement.
The phone at (720) 903-2603 is answered 24/7, and service visits run daily from 8:00 AM to 6:00 PM. Book by phone or through our online scheduling page.
Quick Answers
Littleton Appliance Repair services Fisher & Paykel induction, gas, and electric cooktops throughout Littleton and SW Denver. We've been an independent repair company since 2014 and use OEM-quality, factory-specified parts. Call (720) 903-2603 to book; the phone is answered 24/7.
There is an $89 diagnostic service-call fee that is credited toward your repair if you proceed. The final repair price is set after on-site diagnostics and depends on the part, such as an induction coil, control board, or spark electrode. You always get a firm written estimate before any work begins.
A single dead zone on a CI-series cooktop is usually a failed induction coil or its driver, an overheated power board, or a cooling-fan fault, while a whole-cooktop failure points to the shared power supply. Non-induction cookware also won't heat. A technician can isolate the exact cause on-site rather than replacing parts by guesswork.
FAQ
Anything else — call any hour, a real person answers.
Yes. We work on CI-series induction, CG-series sealed-burner gas, and CE-series radiant electric ceramic cooktops, including drop-in modular sections in older Littleton kitchens.
Often, yes. At Littleton's ~5,350 ft, a burner set up for sea level or an incorrectly converted LPG/NG unit can run rich and burn yellow. We verify the correct orifice and regulator for our elevation and correct the gas-air mix.
Yes. We source OEM-quality replacement glass and burner components for many Fisher & Paykel models. We'll confirm availability for your exact model during the diagnostic visit before ordering.
We schedule service visits daily between 8:00 AM and 6:00 PM across Littleton, Ken-Caryl, Columbine, Chatfield, and Roxborough Park. Call (720) 903-2603, answered 24/7, and we'll find the earliest slot.
Answered 24/7 · $89 diagnostic credited to the repair
Book OnlineReviews
Our built-in Sub-Zero was keeping the freezer fine but the upper fridge zone was sitting around 55. Turned out to be the dual-evaporator setup, exactly what the tech guessed on the phone. Brian had the sealed system diagnosed the first visit, ordered the part, and had us back to normal within the week. He didn't try to sell us a new unit like the last place did.
One of the dual-stack burners on our Wolf range would click and click but never light. He mentioned it's common up here because the burners need to be calibrated for the altitude, which no one had ever told us. Relit perfectly after and he adjusted the others while he was at it.
Fixed our Sub-Zero the same week we called. Fair price, no upsell.
Our dual-zone wine cabinet had drifted so the bottom zone wouldn't hold temp and there was condensation collecting on the glass. They diagnosed it quickly but the part had to come from the manufacturer and took about four days, so we were without it for most of a week. Once it arrived the fix was solid and both zones are holding right where they should. Worth the wait, just be ready for the parts delay on these.
Miele dishwasher wouldn't drain, standing water in the bottom every cycle. Bad drain pump. In and out in about an hour and he cleaned out the filter housing that was part of the problem too.
The door gasket on our 15-year-old Sub-Zero had gotten brittle and it was sweating around the seal. New OEM gasket and it seals like new again. Appreciated that they used the factory part instead of some universal thing.
Thermador wall oven quit heating right before we were hosting. Called in the morning and they got someone out that same afternoon. Bad igniter. He had the part on the truck and we still made our dinner.
Ice maker in our Sub-Zero was making cloudy hollow cubes and barely any of them. He flushed the system, replaced a valve, and now it actually keeps up when we have people over. Nice guy, wore booties in the house without being asked.
Solid work on our Bosch dishwasher, the drain pump had failed. The only thing is the $89 service call fee felt a little steep before I knew they credit it toward the repair. Once I proceeded it came off the bill, so no real complaint, just wish I'd understood that up front.
Our Viking freezer was building up a wall of frost and not defrosting on its own. Turned out to be the defrost heater. Fixed it and explained what was going on so I understood why it happened.
Two burners on our Wolf cooktop wouldn't spark. Tech recalibrated them for the elevation and swapped the igniters. Works better than it has in years honestly.
Warm upper zone on our Sub-Zero, classic apparently. They knew exactly what it was, ordered the evaporator part, and came back to install it a couple days later. Honest and easy to deal with the whole way through.
Not many people around here will even touch a Gaggenau. These guys did, got the control board sorted, and were straight with me about the cost of the part on a unit this expensive.
Miele steam oven throwing an error and shutting off mid-cook. The tech was great and clearly knew the unit, but he ran about 40 minutes behind the window they gave me and I had to shuffle some things around. Fixed it in one visit though and it's been perfect since, so I'd still call them again.
Had them out for our built-in outdoor grill that wasn't lighting evenly. Didn't expect them to do outdoor units but they did and dialed it in for the altitude. Grilling season saved.
Quick, clean, and they answered when I called at 9pm the night before. Dishwasher's draining again.
This was a big one, the sealed system on our Sub-Zero failed and that's a job a lot of shops won't take on. They did it right, used factory-spec parts, and stood behind the work. Given it's a $12k built-in I'm glad I found someone who actually knew these inside and out instead of just replacing the whole fridge.
Wine fridge kept fogging up on the door and the temp was bouncing around. Fixed same visit and no more condensation.